ARMY TM 5-6675-308-12
MARINE CORPS TM 08837A-12/1A
Table 3-3.2. Mission Procedures (GPS) - Continued
Step
Reference
Status indicators
Operation action
CDU data display
no.
D
k.
Press DIST
PAUSE
Enter distance
l.
ID*PAE 111
m.
PADS shows mark results
n.
Load survey equipment and proceed on
mission when indicator has flashing
"GO"
13.
DATA RECALL
Perform lamp test to verify proper lamp
a.
operation. Set lamp intensity to desired
brightness
--(Last display)
Press ID
b.
--
10(Last display)
Enter ID number of desired data. (Ex-
c.
ample: ID10)
10(New display)
Press ENT
d.
10EXX:XXXXXX.X
Press for data desired. (Example: for
e.
easting, press E.) Azimuth information
will only be available for those IDs
where an azimuth was marked. Dashes
will be displayed for grid or true azi-
muth in those IDs where only position
and elevation are marked
f.
An alternate procedure to recall data is
to press +/2 to increase the ID number
by one one press -/8 to decrease the ID
number by one
14.
SHUTDOWN
To prevent damage, do not move or re-
start PADS for at least 2 minutes after
shutdown.
NOTE
The following steps check the PADS
battery operation under load. While it
may be performed at any time during a
mission, it is suggested that it be per-
formed at the beginning of the mission
to minimize impact if a defective battery
is found.
a.
While PADS is operating, note CHRG
indicator is not lighted continuously
3-36.31
Change 3