ARMY TM 5-6675-308-12
MARINE CORPS TM 08837A-12/1A
k.
Secure alignment pin bracket to cargo platform
e.
Remove two forward T-handles securing clamp-
with two D- rings. Secure left side (porro prism
ing brackets to subfloor or mounting base and
side) of primary pallet with two clamping
store in battery box top. Retain clamping
brackets and D-rings.
brackets for later use.
l.
Transfer the battery box to the right cargo plat-
f.
Slide primary pallet forward a few inches to
form. Connect battery cable W6 to PS connec-
disengage alignment pins. Remove two rear T-
tor 3J2. Set PS BATTERY circuit breaker CB1
handles securing alignment pin bracket and
to ON. BATT indicator goes out.
store in battery box top. Retain bracket for later
use.
m. Position battery box locating bracket over
center rear tiedown receptacle. Secure with a D-
g. Remove D-rings from helicopter cargo plat-
ring. Fasten and secure battery-box belt to D-
forms as shown in figure 3-8.
rings on both sides of the battery box.
NOTE
n.
Strap auxiliary gear to cargo platforms.
Save five D-rings for later use. Store the
rest in the battery box top.
o.
Without disconnecting cable W1, remove CDU
from computer bracket and secure to helicopter
h. Set PS BATTERY circuit breaker CB1 to OFF.
leg mount (located in battery box top). Route to
BATT indicator lights. Disconnect battery
passenger's seat.
cable W6 from PS connector 3J2.
Check that helicopter armament power circuit
p.
i.
Raise IMU end of primary pallet so it rests on
breaker is out.
left fender. Rotate the pallet so the IMU end
hangs over the rear panel. Using three persons,
Connect W9P2 of helicopter cable W9 (located
q.
transfer the primary pallet to the helicopter left
in battery box top) to helicopter armament
cargo platform. The porro prism faces out the
power connector under left cargo platform.
door. (See figure 3-9 or 3-10.)
Route between the cargo platforms.
Mate alignment pin bracket to right bottom rail
r.
Set PS VEHICLE circuit breaker CB2 to OFF.
j.
BATT indicator lights. Disconnect cable W8
(side opposite porro prism) of primary pallet.
Adjust alignment pins as necessary.
Previous Page
