ARMY TM 5-6675-308-12
MARINE CORPS TM 08837A-12/1A
Table 3-3.2. Mission Procedures (GPS) - Continued
Step
Reference
Status indicators
CDU data display
Operation action
no.
Press STOP
d.
MARK, ENT Z-VEL
Press MARK (if 2 POS C-E appears on
e.
C-E
display, press CLR)
"READ"
f.
Press ENT
alternate for 64
seconds
Press CLR (to bypass 64-second motion "D"
g.
test). PADS will cue for distance
h.
Measure and record offset distance
D
1
i.
Press DIST
PAUSE
Enter distance
j.
ID*PAE 1-1
k.
PADS shows mark results
l.
Stow equipment, and proceed with mis-
sion after indicator has flashing "GO"
12.
MARKING - POSITION, AZIMUTH,
AND ELEVATION (using theodolite)
a.
Stop vehicle; press STOP
b.
Set up theodolite over point to be estab-
lished
c.
When ready to move ("GO"), maneuver
vehicle and achieve autoreflection
d.
Press STOP
MARK, ENT
Press MARK
e.
C-E
"READ"
f.
Press ENT
alternate for 64
seconds then
"<" .00
Measure and record horizontal angle and
g.
offset distance
h.
PAUSE
Without disturbing vehicle, press <.
PADS will automatically check for azi-
muth motion. Display must be "<" be-
fore this step will be accepted
i.
Azimuth motion within limits (if motion <
is excessive, display will revert back to
C-E and steps f and h must be
repeated)
3-36.30
Change 3