ARMY TM 5-6675-308-34
MARINE CORPS TM 08837A-34/2
Status
CDU Data
Step
Reference
indicators
display
Operator action
no.
NOTE
This table summarizes PADS operational sequences. More detailed descriptions are in the paragraphs listed in the
Reference column.
a. CDU pushbuttons are
underlined e.g., press STOP.
GO
e.g.
b. A lighted status indicator is
shown in Status Indicators
column and remains lighted
until extinguished.
e. An extinguished status
e.g.
indicator is boxed in.
"GO"
.d Flashing displays are
e.g.
enclosed in quotation marks.
These conventions are used
throughout this manual.
1.
Set up equipment as shown in
2.
Turn on +21V power source
and set BATTERY and
VEHICLE circuit breakers
CB1 and CB2 to ON
Note 1
STOP, ENT
"SPH" 1 or
Press ON/OFF
3.
"GPS C-E"
(All lamps light.)
(All lamps light.)
4.
Perform lamp test
NOTE
All fault indicators set
white when LAMP
is pressed and reset black
when LAMP is released.
STOP, ENT
"SPH" 1 or
Set lamp intensity
5.
"GPS C-E"
"ss SPH"
5.1 Enter CLR (for solid state
memory only)
"PAUSE" (for solid
6.
Enter spheroid
state memory only)
"HUM" 1
7.
When "PAUSE" extinguishes,
PADS cues for a vehicle entry.
The cue will be the last vehicle
that had been used. Press ENT
Change 6
Previous Page
