ARMY TM 5-6675-308-34
MARINE CORPS TM 08837A-34/2
3. SUV 3
Susv
Left side driver
sight/plumb bob
4. M151 4
Pintle mounted
Jeep
plumb bob
PADS mounted
5. OH-58 5
OH-58
Helicopter plumb bob arm
PADS mounted
6.
UH-1
6
UH-1
Helicopter plumb bob arm
7. PLMB 7
M151 Jeep PADS mounted
plumb bob arm
e.2 The operator presses CDU /2 or -/8 to ad-
vance or decrement the vehicle selection until the correct
vehicle has been displayed then presses ENT. The
vehicle selection may be changed at any time during
operation which allows vehicle to vehicle transfer while
the system is operational.
e3. If the system has been installed in a vehicle which
is not defined as one of the seven standard vehicles, or
has not had the lever arms previously entered the
operator must enter any choice of vehicles in order to
proceed with the initialization. The procedure for
selecting and inserting data for the nondefined vehicle is
as follows:
(1) While PADS is aligning or preferably after align-
ment is complete, the operator may insert up to three
nonstandard vehicle selections after determining the X,
Y, Z, and V lever arm dimensions using figure 3-1.1 as
an example. All lever arm entries and displays must be
in meters to the nearest millimeter.
Change 6
3-5
Previous Page
