ARMY TM 5-6675-308-34
MARINE CORPS TM 08837A-34/2
Table 3-1. Direct Support Test Procedure - Continued
CDU Data
Status
Step
display
indicators
no.
Operator action
Reference
.0
"E"
Enter spheroid; PADS cues for
8.
easting
.0
"N"
9.
Enter zone and casting PADS
cues for northing
.0
Enter northing PADS cues for
"EL"
10.
elevation
11.
MODE O
Enter elevation; alignment
ENT CAL MON
continues
MODE
1
Note 2
MODE
2
Z-VEL
MODE
3
MODE
4
5
MODE
MODE
6
MODE
7
Alignment ends
MODE
8
12.
OFF C-E
13.
Press ON/OFF
or
SAVE G E
Note 4
Press ENT. PADS shuts down
14.
15.
Disconnect equipment
TEST COMPLETE
Note 1. BATT may light for a few minutes. If it stays lighted verify connections to + 28V power and battery box
and that BATTERY and VEHICLE circuit breakers CBl and CB2 are ON. CHRC may light throughout
the mission.
Note 2. The display may initially show MODE 0, 1, 2, or 3 depending on the speed of coordinate entry. Time since
turnon may be displayed by pressing TIME. The mode may be recalled by pressing MON.
Note 3. MON will extinguish when any other function k selected. No display functions can be selected by the
operator until the survey data has been entered
Note 4. If ON/OFF is pressed and CDU d lay indicates SAVE C-E the computer contains a solid state memory
instead of a core memory and tbe following turn off steps must be performed:
a. Press ON/OFF. Display indicates SAVE C-E
b. Press ENT. Display indicates PAUSE.
c. In approximately 20 seconds the display will indicate "OFF" E.
d. Press ON/OFF. Display indicates OFF "E".
e. Press ENT. System will turn Off.
3-4 Change 5
Previous Page
