ARMY TM 5-6675-308-12
MARINE CORPS TM 08837A-12/1A
(2) Remove locking pin securing CDU bracket to
Remove (+) end lug of cable W7 from the positive
(7)
bracket mounting post on adapter frame. Lift
terminal strip and () end lug from the negative
bracket up and off post.
terminal strip.
Remove protective covers on terminal boxes.
(8)
f. CDU Bracket Replacement. Replace CDU bracket
as described in paragraph 2-13a.
Reinstall negative terminal on battery, replace
(9)
battery cover and close vehicle hood.
g. Cable Assembly W7 Removal.
(10) Disconnect cable W7 from cable W8 in passenger
compartment.
Cable Assembly W7 Replacement. Install cable
f.
To prevent injury to personnel or damage to
assembly W7 as described in paragraph 2-12e.
equipment, all rings, watches, and bracelets
4-20. M998 Series Vehicle Kit Repair
must be removed. Disconnect ground cable
first before working with, or around batteries.
a. Subfloor Plate Removal.
Protect the ground cable from accidental con-
tact with other battery cables or posts. When
(1) Remove battery box, primary pallet and other
finished with work, connect ground cable last.
equipment (see figure 2-31).
(1)
Remove the front commander's seat by opening
(2) Remove four screws and washers securing sub-
latch and lifting seat out of vehicle.
floor plate to adapter frame. Retain all serviceable
hardware.
Disconnect ground connection of battery.
(2)
b. Subfloor Plate Replacement.
Remove the cable interconnecting the positive
(3)
(1) Install PADS modified subfloor plate as described
post of one battery and the negative post of the
other battery.
(2) Install primary pallet, battery box and other
Disconnect the negative branch of the W7 cable
(4)
equipment.
from the negative post of the rear battery.
c. Adapter Frame Removal.
Disconnect the positive branch of the W7 cable
(5)
from the positive post of the front battery.
(1) Remove subfloor plate as described in a., above.
Replace the interconnect cable between the posi-
(6)
(2) Remove five screws and washers securing adapter
tive post of the rear battery and the negative post
frame to vehicle cargo bed. Retain all serviceable
of the front battery.
hardware.
d. Adapter Frame Replacement. Install adapter frame
Replace the battery ground cable.
(7)
as described in paragraph 2-13a.
Replace commander's seat and latch in place.
(8)
e. CDU Bracket Removal.
h. Cable Assembly W7 Replacement. Replace cable
(1) Release two clamping catches and remove CDU
assembly as described in paragraph 2-13b.
from vehicle CDU bracket (see figure 2-15).
4-41/(4-42
blank)
Previous Page
