ARMY TM 5-6675-308-12
MARINE CORPS TM 08837A-12/1A
(5) Radio and Radio Mount Installation. Reinstall the
radio mount, radio, and accessories removed in
Utility Cargo Vehicle (CUCV)
step (2), above. Proceed as follows, referring to
a. Preparation of Vehicle for Installation. Prepare ve-
hicle for installation as follows:
(a) Secure radio mount to vehicle side panel using
six bolts and flat washers. Usc l/2-inch wrench.
Spare Tire Removal. Remove the spare tire for
(1)
working room, if desired. Retain for reinstallation
(b) Install radio on radio mount.
following installation of PADS.
(c) Connect radio power cable to terminal blocks.
(2) Radio and Mount Removal. Remove radio and
radio mount, located adjacent to the rear passenger
b. Mounting Base Installation. Install the mounting
seat on the curbside of the vehicle (figure 2-17), as
base on the vehicle cargo bed as follows:
follows:
Behind the front scats on cargo bed, remove fifth
(1)
(a) Disconnect the radio power cable from thc ter-
and sixth bolts and washers referenced from each
minal blocks in the engine compartment, or from
side panel (total of four bolts and washers), as
the terminal blocks mounted on the vehicle
sidewall just below the radio rack.
Place mounting base on cargo bed. Line up four
(2)
holes in mounting base with holes in cargo bed
(b) Remove the radio and any accessories from the
where bolts were removed.
radio mount.
Place four spacers (from installation kit) between
(3)
(c) Remove the radio mount by removing the six
mounting base and cargo bed at bolt locations.
mounting bolts. Usc a l/2-inch wrench. Retain
Place long end of spacers toward front of vehicle.
the mount and hardware.
(4)
Install four no. 5/16- 18UNC x 1.38 inch long bolts
(3) Rear Passenger Scat Removal. Remove rear seat
(from the installation kit) with flat washers
as follows:
through mounting base and spacers into cargo bed.
Finger tighten bolts.
(a) Using handle at the rear of the rear passenger
seat, lift and fold scat forward, exposing the
Install two J-bolts, anti-rotation washers, lock-
(5)
front mounting bolts (figure 2-18).
washers and 0.500 -20UNC nuts as shown in
(b) Remove two bolts, flat washers, and lock-
Force mounting base forward, then tighten the
(6)
washers securing rear passenger scat to cargo
four bolts and two nuts. Usc l/2-inch and
bed. Use l/2-inch wrench.
13/16-inch wrenchcs.
(c) Remove rear passenger seat through rear door.
c. CDU Mounting Bracket Installation. Install the
CDU mounting bracket as follows:
(d) Reinstall two bolts, flat washers, and lock-
washers in cargo bed.
(1)
Secure nutplate (from installation kit) to CUCV
bracket located on the dash panel, as shown in
(4) Rear Seat Belt Removal. Remove the rear set belt
long screws and lockwashers from kit. Fit
as follows:
nutplate in behind existing dashboard bracket
without removing it.
(a) Remove two seat belt attachment bolts, using
l/4-inch hex head key. Store the belts with the
Secure CDU bracket (from kit) to CUCV dash
(2)
rear passenger seat.
panel bracket with three .250-28UNF x .656-inch
long screws and lockwashers from kit. U s e
7/16-inch wrench.
(b) Reinstall the bolts in cargo bed.
2-25
Previous Page
