ARMY TM 5-6675-308-12
MARINE CORPS TM 08837A-12/1
COMPONENTS OF END ITEM LIST
Section I. INTRODUCTION
c. Part Number (P/N). Indicates the primary num-
B-1. Scope. This appendix lists
integral components of
and basic issue items for the PADS to help you inven-
ber used by the manufacturer, which controls the design
and characteristics of the item by means of its engineer-
tory items required for safe and efficient operation.
ing drawings, specifications, standards, and inspection
B-2. General. The Components of End Item List is
requirements to identify an item or range of items.
divided into the following sections.
d. Description. Indicates the Federal item name
a. Section II. Integral Components of the End
and, if required, a minimum description to identify the
Item. These items, when assembled, comprise the PADS
item.
and must accompany it whenever it is transferred or
e. Location. The physical location of each item
turned in. These illustrations will help you identify
listed is given in this column. The lists are designed to
these items.
inventory all items in one area of the major item before
b. Section III, Basic Issue Items. These are mini-
moving on to an adjacent area.
mum essential items required to place the PADS in
operation, to operate it, and to perform emergency
f. Usable on Code. "USABLE ON" codes are in-
repairs. Although shipped separately packed, they must
cluded to help you identify which component items are
accompany the PADS during operation and whenever it
used on the different models. Identification of the codes
is transferred between accountable officers. The illustra-
used in these lists are:
tions will assist you with hard-to-identify items. This
manual is your authority to requisition replacement BII,
based on Table(s) of Organization and Equipment
Used on
Code
(TOE)/Modification Table of Organization and Equip-
ment (MTOE) authorization of the end item.
AN/USQ-70
DEB
B-3. Explanation of Columns.
a. Illustration. This column is divided as follows:
g. Quantity Required (Qty Reqd). This column
(1) Figure number. Indicates the figure number of
lists the quantity of each item required for a complete
the illustration on which the item is shown (if applica-
major item.
ble).
h. Q u a n t i t y . This column is left blank for use
(2) Item number. The number used to identify
during inventory. Under the Rcvd column, list the
item called out in the illustration.
quantity you actually receive on your major item. The
Date columns are for use when you inventory the major
b. National Stock Number (NSN). Indicates the
item at a later date, such as for shipment to another
National stock number assigned to the item and which
site.
will be used for requisitioning.