ARMY TM 5-6675-308-12
MARINE CORPS TM 08837A-12/1A
(4) Install alignment-pin bracket and adjust pin(s)
in accordance with paragraph 4-15b.
4-2, and 4-7 and replace computer fan as follows:
(1) Removal.
and replace clamping bracket as follows:
(a) Disconnect cable assembly W2 connector
W2P2 from computer connector lJ1 (See
(1) Removal. Remove T-handle securing clamping
bracket to frame; remove clamping bracket.
Replacement. Secure
clamping
bracket
to
(2)
(b) Disconnect cable assembly W3 connector
frame with T-handle.
W3P2 from computer connector 1J4.
e. Alignment-Pin Receptacle Replacement. See
(c) Disconnect cable assembly W1 connector
W1P2 from computer connector 1J3.
follows:
(d) Loosen four captive screws securing com-
(1) Removal.
puter to primary pallet; remove computer.
(See figure 4-2.)
Remove PS in accordance with paragraph
(a)
4-13a(1).
(e) Disconnect cable assembly W5 connector
W5P4 from computer fan connector 5J1.
Remove nut and washer securing alignment
(b)
pin receptacle to frame; remove alignment
(f) Loosen four screws, washers, and clamps
securing computer fan to mounting plate;
pin receptacle. Inside nut requires 3/4-inch
wrench and locking nut requires 1/2-inch
remove fan. (See figure 4-7.)
wrench.
(2) Replacement.
(2) Replacement.
(a) Connect cable assembly W5 connector
W5P4 to computer fan connector 5J1. (See
(a) Secure alignment pin receptacle to frame
with nut and washer.
(b) Replace PS in accordance with paragraph
(b) Install computer fan on mounting plate,
4-13a(2).
oriented with airflow arrow pointing up,
Previous Page
