ARMY TM 5-6675-308-12
MARINE CORPS TM 08837A-12/1A
Table 3-3.2. Mission Procedures (GPS) - Continued
Step
Reference
Status indicators
CDU data display
Operation action
no.
To verify lever arm entries areas de-
ac.
sired, press /8 which will yield lever
arm data located in MON ID locations
(Example)
47 through 50
50V
0.000
Press -/8
49Z
Press -/8
0.432
-1.014
48Y
Press -/8
47X
0.660
Press -/8
If the operator is or is not satisfied with
5 1 G P S 4 11
ad.
the entries, he must again access MON
ID 51. If not satisfied, he must reenter
the lever arms per the preceding steps
If he is satisfied, press MON, ID, 5, 1,
UH-1
6
ae.
then ENT. Press MON and number of
vehicle that is in use, i.e., 6 for UH-1
helicopter, then press ENT
To return to the MODE status, press ID,
MODE
X
af.
ENT
If required, move system to known sur-
ag.
vey control point (SCP) to perform an
update; perform zero-velocity correc-
tions as necessary
3.
SCP UPDATE - POSITION AND
ELEVATION - PLUMB BOB
Maneuver vehicle to place plumb bob
a.
over SCP
b.
Stop vehicle; press STOP
To ensure that the correct vehicle lever
c.
CUCV 2 (example)
arms are in use, press MON, ID, 5, 1,
ENT. The display should indicate the
vehicle in use. If not, select the correct
vehicle
Press UPDT
d.
GPS C-E
UPDT ENT
Press CLR
e.
C-E
Press CLR; PADS cues for casting
f.
"E"0:
.0
"N"
Enter zone and easting; PADS cues for
.0
g.
northing
h.
PAUSE
Enter northing; PADS accepts position
data
i.
"EL"
PADS cues for elevation
.0
Change 3
3-36.23