ARMY TM 5-6675-308-12
MARINE CORPS TM 08837A-12/1A
Table 3-3.2. Mission Procedures (GPS) - Continued
Step
Reference
Status indicators
CDU data display
Operation action
no.
NOTE
BATT may light for a few minutes. If it
stays lighted, verify connections to
vehicle power and battery box and that
PS BATTERY and VEHICLE circuit
breakers CB1 and CB2 are ON. CHRG
may light throughout the mission.
If computer and/or CDU fault indicators
set white at tumon, press LAMP and
observe that they set to black.
If malfunctions are encountered now or
during mission operations, refer to
BATT
Set PS VEHICLE circuit breaker CB2 to
d.
OFF for approximately 30 seconds
Set PS VEHICLE circuit breaker CB2 to
e.
CHRG (within 10)
ON
seconds)
If system shuts down when CB2 is
f.
switched OFF, check cables first, and if
good, replace battery so mission can
continue
If required, drive vehicle to initialization
g.
point and park
h.
Adjust vehicle hand throttle so batteries
charge and engine idle is smooth, with-
out racing engine
(All lamps light)
Perform lamp test, replace faulty lamp
(All lamps light)
i.
modules. Set lamp intensity
NOTE
Fault indicators set white then reset
black when LAMP is released.
GPS C-E
Observe CDU data display
j.
NOTE
It is preferable to enter the GPS mode at
this time to ensure that the GPS receiver
lever arms have been entered into the
computer, even if GPS is not intended
for use.
FOM "1-9"
k.
Press ENT
3-36.20
Change 3
Previous Page
