ARMY TM 5-6675-308-12
Remove two T-handles and clamping brackets
e.
from primary pallet.
f.
Use sockethead key to reinstall isolator blocking
To prevent damage, a primary pallet
pin housing.
must be installed in a transit case when
shipped.
Fasten primary pallet to transit case platform
g.
with three clamping brackets and T-handles.
NOTE
h.
Use sockethead key to loosen two jamnuts. Turn
Return transit case to Battalion Supply
in both isolator blocking pins approximately 1
for storage when PADS has been installed
inch to firmly engage holes in the IMU mounting
in its vehicle.
blocks. Use sockethead key to lock both jamnuts
against the isolator blocking pin housing. Re-
place sockethead key.
Secure primary pallet isolated platform to the
i.
Press pressure relief valve until air pressure is
a.
frame using the upper frame bracket and four
equalized. Unlatch and remove transit case
T-handles.
cover.
Secure CDU to bracket on top of computer.
j.
Remove five T-handles, upper frame bracket, and
b.
clamping bracket from transit case platform.
k.
Check and insure that 48 units of desiccant and
the humidity indicator are in transit case. Re-
c.
Use sockethead key to remove two screws, wash-
place transit case cover.
ers, and lockwashers securing shorter isolator
blocking pin housing.
d.
Set primary pallet onto transit case platform and
engage lower pin assembly in pallet frame
socket. Orient primary pallet with IMU at isola-
tor blocking pins end. If the lower pin does not
freely enter the socket, adjust in accordance with
Previous Page
