TM 5-1260-206-12
Table 2-3.
Initial Adjustment and daily Checks
STEP
ITEM
PROCEDURE
NO.
INTERCONNECTING CABLES
1
Check that all cable connection are made securely.
2
Check all cables for frayed insulation or other visible defects.
CALCULATOR
Calculator power off.
1
DAC power off.
O p e n printer access door. Ensure that line voltage selector
2
switches are set for 120 volts. If adjustment is needed:
a. Insert tip of small crewdriver
into slot on switch.
b.Slide switch so that slot is in
position shown.
Switches shown in 120 v position
3
Check printer paper tape supply. If depleted :
Remove spindle (1) and discard
paper core.
Insert spindle through center
hole of new paper roll ( item 9,
Replace the spindle.
Thread paper through paper slot
(2).
Rotate thumbwheel (3) to advance
paper.
4
Closer printer access door.
2-32
Previous Page
