TM 5-1260-206-12
TABLE 2-2. APPS Assembly Procedures - Continued
STEP
ITEM
NO.
PROCEDURE
Measuring marks (19) - Remove from case 5.
15
40u with zoom eyepieces (2 each).
100u with fixed eyepieces (2 each).
a.
Push photo-carriage to rear of
OMS.
b.
Rotate measuring mark holder
(20).
c.
Using steady pressure, insert
measuring mark in holder.
d.
Rotate holder half turn.
e.
Insert other measuring mark.
f.
Rotate holder until detent seats
16
Lamp assembly (17) - Remove from case 5.
a.
Place light cord in slotted hole on base plate (2).
b.
Insert lamp assembly base in hole.
c.
Tighten screw (18).
17
DIC - Remove from case 2.
18
DAC - Remove from case 3.
19
Calculator - Remove from case 2.
20
Digital Display - Remove from case 2.
21
TID lamp control assembly - Remove from case 4.
Lamp control assembly must be placed at least
4 inches from all other APPS components.
2-30
Previous Page
