TM 5-1260-206-12
APPS Assembly Procedures - Continued
Table 2-2.
STEP ITEM
PROCEDURE
NO.
6
Stereoscope base plate (10) - Remove from case 5.
TID capstan bolts (3 each) (11) - Remove from case 5.
Set base plate on top of TID assembly. Align three holes.
Insert two short capstan bolts in rear holes (12) of base plate.
a.
c.
Insert long capstan bolt in hole on right side of base plate
(13).
d.
Tighten bolts.
Left photo plate (14) - Remove from case 4.
7
Right photo plate (15) - Remove from case 4.
a. S e t left photo plate on left side of photo-carriage.
b. Align two recessed screws (16) with holes in photo-carriage.
c. Using a screwdriver, tighten screws.
d. Repeat for right photo plate.
Photo clips (4 each) (17) - Remove from case 5.
8
Install one clip at each outside corner of both photo plates.
X-axis encoder (1) - Remove from case 4.
9
Rotate X-axis parallax adjust (2)
a.
u n t i l flat side of shaft (3) is
facing upwards.
R o t a t e flexible coupling (4)
b.
u n t i l set screw (5) is facing
upwards.
Push X-axis encoder onto shaft.
c.
d.
Ensure that there is clearance
between shaft and support blocks,
e.
Tighten two knurled knobs (6).
f.
Check that flat side of shaft
and set screw line up.
Rotate X-axis parallax adjust
g.
to ensure free movement of shaft.
2-27
Previous Page
