TM 5-1260-206-12
Initial Adjustments and Daily Checks - Continued
Table 2-3.
STEP "ITEM
NO.
PROCEDURE
Check that selector on I/O connector of cable W102 is set at 2.
5
If adjustment is needed:
a.
Insert tip of screwdriver into
s l o t on selector.
b.
Rotate selector so that arrow
points at 2.
CURSOR COIL
All power off.
1
2
Insert a piece of calculator paper (1) face down between cursor coil
mounting bracket (2) and base plate (3). Check that cursor coil (4)
j u s t clears print. If paper cannot be inserted or if adjustment is
needed:
a. Loosen two locking screws (5).
b.
Move mounting bracket for
c o r r e c t clearance.
c.
Tighten locking screws.
d.
Check that coil moves freely
over datagrid.
e.
Repeat if necessary.
Remove paper.
3
2-33
Previous Page
