TM 5-1260-206-12
APPS Assembly Procedures
Table 2-2.
STEP
ITEM
NO.
PROCEDURE
1
B a s e plate (1) - Remove from case 1.
P h o t o - c a r r i a g e ( 2 ) - Remove from case 4.
a.
Set base plate on suitable table.
Center photo-carriage on top of base plate.
b.
2
P h o t o - c a r r i a g e red holddown screw (3)
Remove red screw from front right corner of photo-carriage.
a.
Store screw in red hole (4) on front right side of photo-
b.
carriage.
P a r a l l e l o g r a m locking screw (5)
3
D o not exert pressure on parallelogram.
a.
R e m o v e locking screw from transport hole.
Place screw in red storage hole (6).
b.
Open parallelogram (7) to position anchor block (8) on baseplate
c.
2-25
Previous Page
