ARMY TM 5-6675-308-12
MARINE CORPS TM 08837A-12/1A
to mobile receiver A. The elevation input would be
Indicates that a GPS position/elevation
g.
ELA2 -
FOM input should be the largest of
mark/update was completed
the FOM values recorded.
Indicates that a theodolite was used to
1
mark position, azimuth and/or elevation
k. Procedures used to update position and/or elevation
Indicates that the PADS plumb bob was
2
used to mark position, azimuth, and/or
elevation
a.
While updating the system, PADS tests the difference
Indicates that a probable error is in the
E
numeric location of the PAE display
-
Indicates that either position, azimuth,
and/or elevation was not marked or
If the difference (error) is within a built-in tolerance,
b.
updated
the update is accepted and the display will read ID
PAE (type of update).
Shown below are examples of the displays.
If the difference (error) is outside the built-in toler-
c.
ance, PADS recues for the data by flashing "E" on the
You have updated position and
1
* PAE U-U
CDU followed by the data the operator entered.
elevation using either plumb bob or
theodolite
The flashing "E' indicates an update rejection for
d.
You have marked position and
2
* PAE 1-1
horizontal position, either casting or northing. A
elevation using a theodolite
flashing "EL" with data indicates an elevation update
You have marked position, azi-
* PAE 111
3
rejection. The operators will check the probable rea-
muth, and elevation using a theodo-
son and take the appropriate corrective action(s) as
lite
outlined in the update rejection troubleshooting
You have marked position and
4
* PAE 2-2
elevation using a plumb bob
3-22.15. PAE Display. At the
completion of an
update or
You have marked position, azi-
* PAE 222
5
mark, PADS summarizes the results by displaying the
muth, and elevation using a plumb
bob
following:
You have marked position, azi-
* PAE 2E2
6
PAEXXX
X(ID)
*
muth, and elevation using a plumb
bob, but there is a probable error in
(X means the value does not matter for this illustration)
azimuth. In this event, you have to
repeat the measurement. An E in
The symbols used in the summary are:
azimuth of a 2-position azimuth
mark indicates that the distance
MEANING
SYMBOL
between points was not at least 100
meters or the travel time between
X(ID)
A numeric display identifying the mark
points was too long
table-data location of a completed mark
Position and elevation were
* PAE g-g
7
or update. The mark table can store
updated using GPS only
50 positions
Position and elevation were
* PAE d-d
8
PAE
Stands for --
Position, --
Azimuth, Eleva-
updated using differential GPS
tion. PAE display with no numeric sum-
* PAE g--
GPS position only update
9
mary indicates a mark or update was not
GPS elevation only update
1 0 * PAE --g
completed
Indicates that an update of position
Trig position only update
U
1 1 * PAE U--
and/or elevation is complete
Trig elevation only update
1 2 * PAE --U
d
Indicates that differential GPS position/
1 3 * PAE d--
GPS differential position only
elevation mark/update was completed
update
3-36.14
Change 3