ARMY TM 5-6675-308-12
MARINE CORPS TM 08837A-12/1A
Table 3-2. Mission Procedures-Continued
CDU data
Status
Step
indicators
Reference
display
no.
Operator action
Note below
STOP. ENT
Press ON/OFF
"SPH" 1 or "SS
c.
SPH" 1 (or last
used spheroid)
NOTE
BATT may light for a few minutes. If it
s t a y s lighted, verify connections to
vehicle power and battery box and that
PS BATTERY and VEHICLE circuit
breakers CB1 and CB2 are ON. CHRG
may light throughout the mission.
I f computer and/or CDU fault in-
d i c a t o r s set white at turnon, press
LAMP and observe that they set to
black.
If malfunctions are encountered now or
d u r i n g mission operations, refer to
Drive vehicle to initialization point and
d.
park
Adjust vehicle hand throttle so bat-
e.
teries charge and engine idle is smooth
Perform lamp test, replace faulty lamp
f.
(All lamps light) Para 3-7
(All lamps light)
modules
NOTE
Fault indicators set white then reset
black when LAMP is released.
STOP. ENT
"SPH" 1 or "SS
Set lamp intensity; Press S P H
g.
SPH" 1
PAUSE
Enter spheroid: PADS accepts spheroid
h.
HUM 1 (or last
PADS cues for vehicle type
i.
vehicle used)
NOTE
PADS will display last vehicle in which
it was used. When selecting vehicle,
p r e s s the + or key until desired
vehicle appears.
Change 2
3-25
Previous Page
