ARMY TM 5-6675-308-12
MARINE CORPS TM 08837A-12/1
c. Connect battery terminal adapters to both lugs
of the cable assembly W6 and cable assembly
W11 as shown in figure 2-8.
NOTE
The primary pallet weight exceeds the
Orient cable assembly W6 to exit battery
two-person lift criteria. Use three persons
box as shown in figure 2-8.
to lift it.
With the power supply end leading, lift
(b)
d. Connect battery terminal adapter of positive
branch of cable assembly W6 to positive post of
primary pallet into the utility truck and
battery as shown in figure 2-8; secure by tighten-
allow the power supply end to rest on sub-
ing nut on battery terminal adapter.
floor plate.
(c)
e. Connect battery terminal adapter of cable assem-
Raise the IMU end of primary pallet high
enough to permit the pallet to be rotated
bly W6 negative branch to negative post of
about the power supply end so that the
other battery as shown in figure 2-8; secure by
IMU end rests on the left rear fender. This
tightening nut on battery terminal adapter.
requires that the pallet frame make approxi-
f. Connect battery terminal adapter of cable assem-
mately a 45-degree angle with the subfloor
bly W11 to positive post of other battery as
plate.
shown in figure 2-8; secure by tightening nut on
Carefully lower IMU end so that primary
(d)
battery terminal adapter.
pallet reaches the position shown in figure
g. Connect negative batatery terminal adapter of
2-10.
cable assembly W11 to negative post of first
(2) Utility truck with hardtop.
battery as shown in figure 2-8; secure by tighten-
ing nut on battery terminal adapter.
(a) Remove spare tire and spare gas container.
(b) Remove rear panel of hardtop.
NOTE
Check that battery connections are posi-
If vehicle is equipped with a gasoline
tioned to not interfere with battery box
fired heater, it may be necessary to loosen
cover and battery filler caps.
two clamps securing flex hose to heater
h . Check that cable assembly W6 is properly
flange and transition joint. Remove flex
routed to clear battery box cover; install cover
hose and clamps. (See figure 2-12.)
on battery box chassis and secure with four
(c) Load primary pallet in vehicle in accord-
clamping catches.
ance with steps 2-11d(l)(b) thru 2-11d(l)(d).
e.
Slide primary pallet rearward until pins of align-
ment-pin bracket are fully mated in alignment
pin receptacles of bottom rail of mounting base
lows:
frame. If alignment pins do not fit freely into
a.
Check that cables are connected as shown in
receptacles, adjust in accordance with paragraph
b.
Remove four T-handle assemblies (index no. 7,
f.
Secure forward bottom rail of pallet frame to
subfloor with two clamping brackets and T-han-
(index no. 8, figure 1-2) and two clamping track-
dles.
ets (index no. 13, figure 1-2) from stowed posi-
Load battery box as follows:
tions on mounting base frame.
g.
c.
Secure alignment pin bracket to rear of subfloor
using two T-handles. The alignment pins face
forward.
Check that power supply (PS) circuit
d.
Load primary pallet into vehicle as follows:
breakers CB1 and CB2 are in the OFF
position.
(1) Standard utility truck.
(1) Bring battery box through right side into cargo
(a) Remove spare tire and spare gas container,
area of utility truck. Place battery box on
and clear rear canvas, if any, out of the way.
subfloor plate between angle brackets (figure
PADS will come in over the rear panel (See
2-15
Previous Page
