ARMY TM 5-6675-308-12
MARINE CORPS TM 08837A-12/1
Battery box contains acid-filled batteries
Install subfloor plate and subfloor mount-
heat and ignition sources away. Do not
allow battery liquid to touch skin or
clothing. If battery liquid touches skin,
perform CDU bracket installation as follows:
flush area immediately with water; if it
touches the eyes, flush immediately with
(1) Remove dashboard handle, if still in place.
water for 30 minutes and see a physician
Locate three holes which were drilled in dash-
without delay.
board during winterization kit installation.
(2) Using hardware supplied in M151 series vehi-
NOTE
cle winterization kit, install utility truck CDU
Use battery carrier to lift batteries.
bracket and secure to the dashboard with
a.
Obtain two Type BB-249/U (2HN) batteries and
screws (10/32-thread, 7/16-inch length).
install in battery box chassis, oriented as in figure
2-8.
c. Cable W7 Installation. Install cable W7 as de-
Install battery retainers and secure with hook
b.
bolts, washers, and nuts. Place a battery terminal
cover on each battery terminal, oriented with the
bend toward the closest side of the battery box
perform PADS battery installation as follows:
chassis.
NOTE
Battery terminal adapters have different
sized holes for positive and negative ter-
minals and are marked P + and N--, re-
spectively. Install the adapters on the
To prevent injury to personnel while
ends of the cables marked with the same
working on batteries, all rings, watches,
polarity.
bracelets, etc. must be removed.
Figure 2-7. CDU Bracket Installation in
Winterized Utility Truck
2-13