ARMY TM 5-6675-308-12
MARINE CORPS TM 08837 A-12/1A
4793-077
Install a bolt (3/8-inch diameter), flat washer,
(9)
cable clamp, and seat belt or large flat washer,
and (under chassis), large flat washer, lock-
To prevent damage to equipment, ensure
washer, and nut. Use a 9/16- and a 5/8-inch
polarity of cable lugs match polarity of
wrench.
battery posts. The positive wire is color
coded red and the negative, black. See
(10)
Reinstall utility truck battery-terminal cover
and ground cable, removed in step (2), on
tion.
negative post of right battery.
Connect positive (+) lug of cable W7 to
(5)
(11)
Reinstall utility truck battery box cover.
positive battery terminal adapter on positive
post of left battery. Use 9/16-inch wrench.
Connect negative () lug of cable W7 to the
(6)
utility truck negative battery terminal adapter.
The PADS installation kit can be installed by the
Use 9/16-inch wrench.
operators in an M151 utility truck equipped with hard-
top and/or gasoline heater only after the vehicle has
(7)
Using a 9/16- and a 5/8-inch wrench, remove
been equipped with a vehicle winterization kit modified
seat belt anchor bolt, seat belt, washer and nut
by direct support maintenance personnel.
from passenger side outboard seat belt hole. If
seat belts are not installed, there may be a
plastic plug in this hole; remove plastic plug.
If seat belt holes do not exist, a hole must be
a. Subfloor Installation.
drilled by direct support maintenance personnel
on outboard passenger side well (see figure 2-6,
NOTE
detail B) in accordance with TM 5-6675-308-34
or Marine Corps TM 08837A-34/2.
Cut away any thermal insulation where
Install cable clamp over cable W7 and posi-
subfloor and mounting bracket are at-
(8)
tion cable to allow clearance for seat and tool
t a c h e d to the vehicle to make good
compartment lid.
metal-to-metal contact.
Previous Page
