TM 5-6675-270-15
the lead screw and stop nut for burs, wear, and
damage.
the horizontal slowmotion screw assembly.
c. Repair. Remove all burs. Chase threaded
parts having minor thread damage. Replace all
b. Adjust the horizontal slowmotion screw
defective parts that cannot be repaired.
Section VIII. HORIZONTAL CIRCLE HOUSING AND INNER BASE
cables, and contacts.
The horizontal circle housing and inner base in-
b. Inspection. Inspect the horizontal circle
clude the instrument receptacles, contacts and
housing and inner base for cracks, burs, dents,
electrical connections for nighttime operation, the
and other damage. Inspect the electrical cables
horizontal clamp assembly, and the vertical axis
for damaged insulation and broken or frayed
assembly, Components of the horizontal circle are
also included. The horizontal circle housing and
and damaged terminals. Inspect the clamp assem-
inner base, when installed on the instrument are
bly for burs and excessive wear. Inspect all hard-
located between the tribrach assembly and the U-
ware for damaged threads and heads.
frame.
c. Repair. Remove all burs and minor dents,
Chase threaded parts having minor thread dam-
age. Replace defective parts that cannot be
a. Remove the horizontal circle housing and
repaired.
zontal circle housing and inner base.
a. Refer to
figure 5-6 and
assemble the
hori-
zontal circle housing and inner base.
6-31. Cleaning, Inspection, and Repair
b. Install the horizontal circle housing and
a. Cleaning. Clean all metal parts with a clean-
ing solvent and dry thoroughly. Remove dirt and
Section IX. HORIZONTAL CLAMP ASSEMBLY
b. Inspection. Inspect the knob, bushing, pin,
horizontal clamp, clamp jaw, and tube connector
The horizontal clamp assembly, located on the
for burs, dents, and excessive wear. Inspect the
right side of the horizontal circle housing assem-
lockring, clamp, and clamp lever for cracks and
bly, serves to lock the rotatable U-frame in any
breaks.
horizontal position until the clamp is released.
c. Repair. Remove all burs, dents, and nicks.
Replace defective parts that cannot be repaired.
the horizontal clamp assembly.
6-35. Cleaning, Inspection, and Repair
horizontal clamp assembly.
a. Cleaning. Clean all parts with a cleaning
solvent.
Section X. HORIZONTAL CIRCLE ASSEMBLY AND OUTER VERTICAL AXIS
a. Remove the horizontal circle assembly and
The horizontal circle assembly is a glass circle
graduated in degrees or roils, depending on the
model, and is used to measure azimuth angles.