TM5-1260-206-34
Table 2-10.
APPS System Fine Alignment Procedures - Continued
STEP
ITEM
No.
PROCEDURE
Fine Alignment
28
NOTE
When moving photo-carriage with adjust
screw, always approach desired meter or
oscilloscope indication from the same
direction. If desired indication is
overshot, back up past it and continue.
Do the following procedure:
Rotate adjust
Y Display
Observe
screw (14)
Adjust
indication
R70
a.
Clockwise
Changes from 0.124 to
0.125
Alignment Meter
b.
Counter-
High-to-low
clockwise
transition
on center
grid line
(See step 27.)
Zero system.
c.
Repeat steps a. through c. until no further adjustment is
d.
needed.
Zero system. (See step 27.)
e.
R65
Changes from
Clockwise
f.
0.062 to 0.063
Alignment meter
2-46
Previous Page
