ARMY TM 5-6675-308-34
MARINE CORPS TM 08837A-34/2
Legend for Figure 4-15
12.
Washer
1.
Screw
13.
Guide pin
Washer
14.
Captive screw
Cover
5V power supply circuit card assembly Al
15.
RFI gasket
4.
Wedgelock
16.
Wiring harness A3
5.
17.
Screw
Screw
6.
Captive screw
18.
Washer
7.
End plate
19.
8.
Spacer
20.
Captive screw
Nut
9.
Gasket
21.
Chassis
10.
15V power supply circuit card assembly A2
22.
11.
Screw
Card
Part no. location on card
reference designator
part no.
index no.
Near top (opposite connector end) along
15
880595-6 (preferred)
5V power supply circuit card
side edge on component side
8805954:880595-5,
assembly Al
880770-7,880770-8,
880770-9, and 880770-11
(alternates)
Near top (opposite connector end) along
15V power supply circuit card
22
880598-1 (preferred)
side edge on component side
assembly A2
880780-14,880793-3,
8807934,880793-5,
and 880793-6
(alternates)
In middle on side that wire harnesses
5
880753-2
Wiring harness A3
connects
1. Loosen 10 captive screws (20) securing
5. Tighten two screws (17) in wedgelocks
end plate (19) to chassis (10); remove end
(16) until wedges are tight against edge of
plate.
slots.
2. Loosen four screws (17) securing wedge-
6. Inspect gasket (21) on end plate (19).
locks (16) until 5V ower supply circuit
Replace if cracked, tom, or excessively
card assembly Al (
15) and 15V power
compressed.
supply circuit card assembly A2 (22) are
free.
7. Secure end plate (19) to chassis (10) with
10 captive screws (20).
NOTE
(2) Wiring harness A3 Remove. repair. and re-
It may be necessary to loosen the wedges
place wiring harness A3 (5, figure 4-15) as follows:
if they become frozen. This can be done
by simply tapping the wedge screws
(a) Removal.
Change 7
Previous Page
