ARMY TM 5-6675-308-34
MARINE CORPS TM 08837A-34-2
(1) Remove the five cap screws and washers securing
b. Drill two holes using a V2-inch electric drill and a
angle bracket to vehicle gutter. Retain for future
l-inch hole cutter. Install rubber grommets in new
use.
holes.
(2) Remove the screws and washers securing side
3-28. Modification of Subfloor Plate. The subfloor plate
mounting and bottom plates to vehicle body:
must be modified before it can be mounted in the HMMWV
remove rear panel. Retain the screws for future
for pads installation. The modification consists of drilling
use.
two holes, located as shown in figure 3-20. Use a l/2-inch
electric drill and a 7/16-inch drill bit.
OH-58C helicopter pallet must be modified before the PADS
can be installed in the helicopter. The modification consists
of drilling four new holes and installing four sleeves and
(SUSV), Series M973. The SUSV must be modified before
plugs. Sce figure 3-17 and modify the OH-58C helicopter as
the PADS can be installed in the vehicle. The modification
follows:
consists of drilling a hole through the inner vehicle body for
insertion of the battery vent tubing and modification of the
a. Drill four new holes in pallet locations shown in
vehicle wiring harness, proceed as follows:
b. Install sleeves and plugs in new holes. Sleeves and
a. At right rear of vehicle, using a pencil and a scale
plugs from existing holes in pallet can be used.
from shop supplies, extend a line from bottom edge of
the seat belt bracket forward 2.00 inches. Mark with
an X. See figure 3-21.
(CUCV), Series M1OO9. The CUCV must be modified
before the PADS can be installed in the vehicle. The
modification consists of drilling three holes in the vehicle
b. Using a -inch electric drill and a 9/32-inch
firewall to allow power cable W7 to be routed through for
diameter bit, drill a hole through the inner vehicle
connection to terminal boxes mounted in the engine
body at the marked point. The hole is for the battery
compartment. See figure 3-18 and modify the vehicle as
vent tubing.
follows:
a. Cut through insulation and backing to the vehicle
c. At left rear of vehicle, using shop knife, cut plastic tie
firewall to the approximate dimensions shown in
wraps holding the harness that contains connector P42
to the negative battery terminal.
b. Drill three holes through the vehicle firewall where
shown in figure 3-18, using a l/2-inch electric drill
d, Loosen clamp located behind the battery to free.
and a l-inch diameter hole cutter. Install rubber
connector P42.
grommets in new holes.
e. Locate wire no, 8K in connector P42, male pin 2.
Wheeled Vehicle (HMMWV), Series M998. "The
HMMWV must be modified before the PADS can be
installed in the vehicle. The modification consists of drilling
f. Using a pair of wire cutters, cut wire no. 8K about 3
two holes in the vehicle transmission tunnel to allow power
inches from connector P42. Strip both cut ends about
cable W7 to be routed to the vehicle battery compartment.
1/4 inch, using wire strippers.
See figure 3-19 and modify the vehicle as follows:
a. Locate and mark the two holes, centered in the flat
g. Obtain cable assembly 97403-13222E2492 and splice
area of the transmission tunnel adjacent to the existing
from installation kit. Splice cable assembly to wire
radio cable and grommet. Space the holes as shown in
no. 8K as shown in figure 3-22. Crimp both ends of
splice.
3-60
Change 5
Previous Page
