ARMY TM 5-6675-308-34
MARINE CORPS TM 08837A-34/2
Figure 3-16. Utility Truck Winterization Kit Installation Diagram (Sheet 9 of 9)
d. Install Bottom Plate 88052S (6, figure 3-16,
centerline of the six screw holes (four 5/18-
inch diameter holes and two 1/4-inch diame-
sheet 3) on Rear Panel.
ter holes) are aligned within 0.900 to 0.960
(1)
Locate centerline of rear panel near its bot-
inch from outboard edge of rear panel. Locate
tom edge and mark location.
top edge of side mounting plate 1/16 inch
below top edge of rear panel.
(2)
Place top of plate (6) parallel to bottom edge
of rear panel.
(2) Using side mounting plate as a template, cen-
ter punch the screw hole locations in rear
(3) Center the bottom plate about the centerline
panel, Remove side mounting plate.
of the rear panel and locate centerline of the
top screw holes 0.340 to 0.400 inch from rear
(3) Drill the screw holes through rear panel to the
panel bottom edge.
diameters shown in figure 3-16, sheet 2. Use
l/4-inch and 5/M-inch drills, as applicable.
(4)
Using bottom plate (6) as a template, center
punch the four top screw holes. Remove bot-
Place mounting plate 880528-1 (14) on inner
(4)
tom plate.
surface of rear panel and side mounting plate
880524-1 (7) on outer surface of rear panel.
(5)
Drill four 5/16-inch screw holes through rear
panel.
(5) Align the screw holes in the plates with the
screw holes in rear panel.
(6)
Install four 1/4-28 X 3/4-inch screws (8), flat
washers (4), and locknuts (3) and secure bot-
(6) Install the four 1/4-28 X 3/4-inch screws (9),
tom plate to rear panel.
washers (8) and locknuts (10) and tighten.
e. Install Angle Bracket 880523 (4, figure 3-16,
(7) Place handle (6) in position on side mounting
plate and secure with two 10-32 X 3/4-inch
sheet 4).
screws (13), lockwashers (12), and washers
(1) Place angle bracket (4) at top of rear panel.
(11).
Align top of 3/4-inch lip even with top edge
(8) Repeat steps (1) through (7) for left side using
of rear panel and edges of 1 1/4-inch lip
equidistant between inner edges of left and
880524-2 side mounting plate.
3-56
Previous Page
