TM 5-1260-206-12
CHAPTER 3
MAINTENANcE INSTRUCTIONS
SECTION I.
LUBRICATION INSTRUCTIONS
3-1.
LUBRICATION - None required.
SECTION II.
REPAIR PARTS, SPECIAL TOOLS, TMDE,
AND SUPPORT EQUIPMENT
3 - 2 . COMMON TOOLS AND EQUIPMENT - For authorized common tools and
equipment, refer to the Modified Table of Organization and Equipment
(MTOE) applicable to your unit.
3-3. SPECIAL TOOLS, TMDE, AND SUPPORT EQUIPMENT - No special tools,
Test, Maintenance, and Diagnostic Equipment (TMDE), and support equip-
ment are required for organizational maintenance.
3-4. REPAIR PARTS - Repair parts for this equipment are listed in the
Repair Parts and Special Tools List, TM 5-1260-206-24P covering organi-
zational maintenance.
SECTION III.
TROUBLESHOOTING PROCEDURES
3-5.
SCOPE -
a. Table 3-1 lists the common malfunctions which you may find
during operation or maintenance of the APPS or its components. You
should perform the test/inspections and corrective actions in the order
listed.
b. This manual cannot list all malfunctions that may occur, nor
a l l tests or inspections and corrective actions. If a malfunction is
n o t listed or is not corrected by listed corrective actions, notify your
supervisor.
3-6. TROUBLESHOOTING TABLE - Table 3-2 lists troubleshooting procedures
for the APPS. Before doing these procedures:
Check that system is properly assembled
Check that all cable connections are secure
Check that all switches are in the proper positions
Perform initial adjustments and daily checks given in
3-1
Previous Page
