TM 5-1260-206-12
Table 2-5.
APPS Disassembly Procedures - Continued
STEP
ITEM
NO.
PROCEDURE
21
P h o t o - c a r r i a g e (1)
Do not exert pressure on parallelogram.
a . Slide anchor block (2) towards photo-carriage.
b . Align hole (3) at front of anchor block with standoff (4)
at rear of photo-carriage.
c. Remove red locking screw (5) from storage hole. Insert in red
transport hole (3).
d . Tighten locking screw.
e . Rotate parallax adjust screws (6) and (7) until transport hole
(8) in right photo plate aligns with hole in photo-carriage.
f. Remove red screw (9) from red storage hole (10) at front of
photo-carriage and insert in transport hole.
g. Tighten screw.
h . Pack photo-carriage in case 4
2-48
Previous Page
