ARMY TM 5-6675-308-34
MARINE CORPS TM 08837A-24/2
Malfunction
indication/correctie action
Normal indication
Teat procedure
1. TEST SETUP
Check that the diagnostic align-
ment program is loaded into the
computer is memory and that the
computer is functional in accor-
.
dame with table 4-6, 4-6.1, 4-6.2,
or 4-63.
2. COMPUTER DIAGNOSTIC
TEST
NOTE
During this test, any failure message listed in table 4-10 maybe printed. Perform corrective action specified in table 4-10.
If a memory is replaced, operate and reload per tables 4-6 through 4-6.3 dependent upon memory and reader tapes. After
replacing any other card, repeat the diagnostic test from step 2a (table 4-7). If the checksum is incorrect, reload the
diagnostic-alignment program for core memory, or main program for solid state memory.
EXECUTE switch-indicator lights
2a. Press EXECUTE switch-in-
dicator go on to start diagnostic
program
TTY printa out:
PADS DIAGNOSTIC ALIGNMENT
PROGRAM or PADS
SOLID STATE DIAGNOSTIC
ALIGNMENT PROGRAM
PRoGRAM CHECKSUM XXXXXX
SELECT TEST MODE
TTY prints out
TTY prints out:
2b. Type character set CMP (selects
computer automatic test mode)
XXX TEST FAIL
Refer to table 4-10 for corrective
COMPUTER AUTOMATIC
action. Type STS and refer to
TEST MODE
NOTE
TTY prints out at leas than 8 minute
2c. PADS teat set is now in the com-
intervals
puter automatic teat mode and
If TTY prints O Ut: XXX TEST
requires no operator control for
XXX TEST CYCLES PASS
FAIL press PADS ON/OFF switch-
approximately 15 minutes
indicator and ENTER switch. Wait
2 to 3 minutes then turn PADS on,
Where XXX is a number of passes
press EXECUTE switch-indicator,
through test program
and return to step 2a, table 4-7.
Change 6
4-56
Previous Page
