ARMY TM 5-6675-308-12
MARINE CORPS TM 08837A-12/1A
(10) Remove protective covers from positive (+) and
(-) end lug of cable W7 to the center terminal of
negative (-) terminal boxes located on the engine
the negative strip. Refer to figure 2-24. Replace
compartment firewall.
protective covers on terminal boxes.
(11) Connect (+) end lug of cable W7 to the second ter-
(12) Reinstall negative (-) terminal on battery, replace
minal from the right on the positive strip and the
battery cover and Close vehiclc hood.
4793-038
f. Power Co nnect ions, Complete power connections
NOTE
as follows:
The following step applies only to the CUCV
where the terminal boxes are located on the
(1) Connect W6 cable (item 6, figure 1-5) from
curbside rear wall under the radio mount.
battery box to power supply connector 3J2 (See
(3) Connect W7 cable connector, W7P1, to power
supply connector, 3J4. Scc figure 2-25.
NOTE
g. Plumb Bob Bracket Installation. Referring to fig-
The following step applies only to the CUCV
where the terminal boxes are located in the
engine compartment.
(1) Remove top two bolts, lockwashers and nuts
from CUCV pintle. Use 3/4-inch wrench.
(2) Connect W8 cable connector, W8P1, to power
(2) Secure plumb bob bracket (part of installation kit)
to pintle using the bolts, lockwashers and nuts
setup). The power supply is on the right side of the
removed in (1), above.
PADS primary pallet as installed in the CUCV.
Change 2
Previous Page
