17. Insulation tube
1.
Cable
18.
Lamp
contact
Connector
plug
(3
rqr)
2.
19. Lamp
Screw
(spec)
3.
20.
Shade
tube
Spring
4.
21.
Insulation
washer
Contact
spring
5.
22.
Nut
(spec)
Screw
(spec)
6.
23.
Screw
(spec)
Nut
(3
rqr)
7.
24.
Body
tube
Housing
(6
rqr)
8.
25.
Switch
lever
9. Screw
(spec)
(6
rqr)
26.
Contact
terminal
sleeve
10. Prong
(6
rqr)
27.
Pin
11.
Screw
(spec)
(3
rqr)
28.
Switch
insulation
12.
Connector
cable
29.
Insulator
tube
Hook
13.
30.
Contact
sleeve
14.
Setscrew
(spec)
(2
rqr)
31.
Cover.
15.
Lamp insulation
16.
Lamp
housing
Hand
lamp
and
cable
assembly,
exploded
view.
(4)
Remove
the
nut
(22)
and
insulation
(2) Remove the screw (3) which holds the
washer (21) from the lamp contact (18). Remove
s w i t c h insulation (28) in place from the body tube
the two setscrews (14) and remove the lamp
( 2 4 ) . Unscrew the cover (31), keeping track of the
housing
(16)
from
the
lamp
insulation
(15).
n u m b e r of turns required to disengage it from the
R e m o v e the contact (18) and insulation tube (17)
body tube.
f r o m the lamp housing (16). Remove the lamp (19)
(3)
Use
a
narrow
screwdriver
to
press
from the lamp housing.
d o w n w a r d and backward on the switch lever (25)
(5) Remove the screw (6) and lift off the
until the switch lever is inside the body tube (24).
t e n s i o n spring (4) and contact spring (5). Remove
R e v e r s e the direction of travel of the switch lever
the insulator tube (29) and contact sleeve (30) from
a n d switch insulation (28) carrying the lever, and
the switch insulation (28).
push the lamp insulation (15) and switch insulation
(6) Drive the pin (27) out of the switch in-
a l t e r n a t e l y forward far enough to remove the hook
sulation (28) and remove the switch lever (25).
r a t c h e t (13) from the body tube (24). Reverse the
(7) Remove the connector plug (2) following
t r a v e l of the lamp insulation (15) and switch in-
t h e instructions given in paragraph 2-30.
sulation (28) and remove them from the rear end of
(8) Unsolder the contact sleeve
(30) and
the body tube.
NOTE
contact terminal sleeve (26) from the
cable (1).
The two insulations are removed by pushing first
Remove the cable (1) from the switch
insulation
one
and
then
the
other,
progressively,
toward
and
(28). Remove the cover (31) from the
cable (1).
then out of the cover end of the body tube.
Previous Page
