TM 5-1260-206-12
2-7. OPERATING PROCEDURE - Table 2-4 provides procedures for equipment
turn-on and turn-off. Refer to the specific operator's program descrip-
tion provided with each PPDB for instructions peculiar to a particular
PPDB.
If a malfunction occurs, set all power switches at OFF.
Refer to paragraph 3-5, troubleshooting procedures.
If power should go OFF during operation, set all power
switches at OFF to prevent equipment damage.
Do not allow any object to strike or mar datagrid surface.
Do not allow food, drink, smoking ashes, or other similar
materials to come in contact with datagrid surface. Damage
to the datagrid may result.
Do not touch mirrors, lenses, or prisms with fingers. Do
not place any of these components face down on any surface.
Smudging or scratching of these optical components may re-
sult.
Do not lean on measuring unit during or between measure-
ments. Leaning on measuring unit can result in inaccurate
computations by the calculator and damage to OMS.
Do not place any tape cartridge near TID control assembly
or any magnetic field. Erasure of data stored on tape may
result.
Do not switch lamp or power switches on or off during
equipment operation. Check that TID lamp control assembly
is at least 4 inches from all other APPS components. Era-
sure of calculator memory may result.
Do not remove plastic protection cover from calculator
RECORD key.
2-40
Previous Page
