Figure 11. Terminal box (inside).

TB 55-1905-202-34/1

Figure 11. Terminal box (inside).

c. Drill or cut a 1.375 0.03 inch diameter hole to

NOTE

First, it may be necessary to remove

be located on the control console (fig. 10). Weld pipe

coupling (44, fig. 12) in place.

either a square metal tray (for magnetic

compass mounting) or a pair of metal

brackets (for mark 27 gyro compass

12. lndicator Mounting Preparation

mounting) to clear the area.

With

a. Place indicator mounting plate (10, fig. 14) on

indicator mounting plate in centralized

control console and position so that plate is centralized

position, use a template and locate and

among the instrument cluster. If indicator mounting

drill the 12 mounting holes. Locate and

plate interferes with any of the installed instruments and

cut the 5-inch square cutout. See figure

will not lie flat on panel, trim plate as required to fit.

13.

Index