TM 55-1905-223-24-14
(16) Dress cable (1) inside of pelorus stand.
(17) Position cover plate (6) on pelorus stand (4) and secure with eight lockwashers (8) and pan head screws
(7).
(18) Secure cable (1) cable gland to pelorus stand (4).
(19) Assemble stuffing tube (5) to other end of cable (1) and route cable into bearing repeater (2).
(20) Connect cable (1) wiring to terminal board (13). Remove tags.
(21) Dress cable (1) inside of bearing repeater (2) and secure stuffing tube (5).
(22) Position cover (12) on bearing repeater (2) and secure with eight flat washers (11), lockwashers (10), and
screws (9).
(23) Loosen two pivot nuts (16) and rotate bearing repeater (2) in pelorus stand support plate (3) to normal
viewing position. Secure pivot nuts (16).
(24) Synchronize bearing repeater with gyro compass. Refer to TM 55-1905-223-10.
WARNING
Ship's ac power is present at FUSE F1 and POWER switch S1 terminals on inside of
cabinet cover. THESE VOLTAGES ARE DANGEROUS. Use extreme care when
working inside of cabinet.
(25) On relay transmitter (1, FIGURE 2-12) loosen four retaining clips (2) and open cabinet cover (3).
(26) On A2 circuit card assembly (4), set appropriate repeater toggle switch (5) to ON.
(27) Close cabinet cover (3) and secure four retaining clips (2).
(28) Remove "Out of Service" tag.
2-57
Previous Page
