TM 55-1905-223-24-14
g. Remove cover (9) from bearing repeater (2) as far as cabling will allow.
h. Tag and disconnect cable (1) wiring connections from terminal board (10).
i.
Disassemble stuffing tube (5) from cable (1) and pull cable (1) from bearing repeater and cover (9).
j.
Replace cover (9) and secure with eight flat washers (8), lockwashers (7), and screws (6).
k.
Loosen pivot nuts (12) and rotate bearing repeater (2) in support plate (3) to upright position.
CAUTION
The following step requires two soldiers to support removal of bearing repeater, to prevent dropping and
damaging the unit.
l.
While supporting bearing repeater (2), loosen two pivot nuts (12), back out two pivot screws (11), and remove
bearing repeater (2) from pelorus stand repeater support (3).
FIGURE 2-12. Relay Transmitter.
2-48
Previous Page
