TM 55-1905-223-24-14
i.
Remove repeater cables (13, 14, 15, 16, 17, 18, 19, and 20, Sheet 1) by pulling each from the cabinet through
cable entrance plate (21).
j.
Close cabinet and secure four fasteners (2) by securing four pan head screws (12).
CAUTION
Two soldiers are required for the following step because of relay transmitter weight (60 pounds).
k.
Support relay transmitter (1, Sheet 1) and remove four mounting bolts (3) from bulkhead through mounting holes,
and remove relay transmitter.
REPLACEMENT
CAUTION
Two soldiers are required for the following step because of relay transmitter weight (60 pounds).
a. Position replacement relay transmitter (1, Sheet 1) by aligning bulkhead mounting holes on bulkhead and secure
with four mounting bolts (3).
b. Open cabinet of relay transmitter (1) to position indicated in FIGURE 2-7, Sheet 2.
c.
Route repeater cables (13, 14, 15, 16, 17, 18, 19, and 20, Sheet 1) through appropriate holes on cable entrance
plate (21). Cables should fit snugly.
d. Connect cables (13, 14, 15, 16, 17, 18, 19, and 20, Sheet 1) to terminal boards (26, Sheet 2) A2TB4, (25)
A2TB3, (24) A2TB2, and (23) A2TB1. Remove tags.
e. Assemble stuffing tubes (11) on cables (9 and 10).
f.
Route cable (9) through appropriate hole in bottom of relay transmitter (1).
g. Connect cable (9) leads to terminal board (22) TB1. Remove tags.
h. Dress cable (9) inside of cabinet and secure stuffing tube (11).
i.
Route cable (10) through appropriate hole in bottom of relay transmitter (1).
j.
Connect cable (10) leads to terminal board (27) A2TB7. Remove tags.
k.
Dress cable (10) inside of cabinet and secure stuffing tube (11).
2-34
Previous Page
