TM 55-1905-223-24-14
CHAPTER 2
UNIT MAINTENANCE INSTRUCTIONS
Page
Section
I.
Repair Parts, Special Tools; Test, Measurement, and
Diagnostic Equipment (TMDE); and Support Equipment .......................................
Section II.
Service Upon Receipt ...........................................................................................
Section III.
Unit Preventive Maintenance Checks and Services (PMCS) .................................
Section IV.
Unit Maintenance Troubleshooting. .......................................................................
Section V.
Unit Maintenance Procedures ...............................................................................
Section VI.
Preparation for Storage or Shipment .....................................................................
Section I. REPAIR PARTS, SPECIAL TOOLS; TEST, MEASUREMENT,
AND DIAGNOSTIC EQUIPMENT (TMDE); AND SUPPORT EQUIPMENT
2-1. Common Tools and Equipment . For authorized common tools and equipment, refer to the Modified Table of
Organization and Equipment (MTOE) applicable to your organization.
2-2. Special Tools, TNDE, and Support Equipment . Special tools; test, measurement, and diagnostic equipment;
and support equipment requirements are listed and illustrated in the Repair Parts and Special Tools List (RPSTL),TM 55-
1905-223-24P. These items are also listed in the Maintenance Allocation Chart (MAC), Appendix B of this manual.
2-3. Repair Parts. Repair parts are listed and illustrated in the Repair Parts and Special Tools list (RPSTL), TM 55-
1905-223-24P.
Section II. SERVICE UPON RECEIPT
2-4. Checking Unpacked Equipment.
a. Inspect the equipment for damage incurred during shipment. If the equipment has been damaged, report the
damage in accordance with the instructions of DA Pam 738-750.
b. Check the equipment against the packing slip to see if the shipment is complete. Report all discrepancies in
accordance with the instructions of DA Pam 738-750.
c.
Check to see whether the equipment has been modified.
d. Remove protective caps, plugs, inserts, wrappings, and tape when inspection inspection/inventory is completed.
Inspect piping openings for damage. Wipe off dirt, grease, or protective films at time of installation.
2-1
Previous Page
