ARMY TM 5-6675-308-12
MARINE CORPS TM 08837A-12/1A
(c) Inboard bolt goes through the hull and has a
(9)
locking nut on the inside, This nut can be
follows:
reached from the inside of the vehicle by re-
moving the engine cover and reaching down to
(a) Using a 13-mm open-end wrench, remove two
the left, or preferably, accessed from the out-
bolts holding dash panel handleon dash panel on
side rear of the vehicle next to the muffler to
right-hand side of vehicle. See figure 2-37.
the right.
(b) Place bolts in a plastic bag and mark "For
(d) Remove bolts and seat belt.
attaching dash panel handle. Install with 13-mm
open-end wrench." Tie bag and attach to dash
panel handle. Set aside for later use.
(e)
Replace two bolts. Tighten bolts.
(10) Removal of Battery Box Cover. Remove cover
Fold seat belt, place in a plastic bag, and mark
(f)
as follows:
"Seat belt for right rear passenger seat. Use
17-mm open-end wrench." Tie bag and stow in
(a) Open left rear door, unclip and remove battery
SUSV toolbox.
box cover which is the bottom part of the rear
seat. Set cover aside, to be replaced later.
(7)
Panel. Remove access panel as follows:
(b) Disconnect cable to negative terminal (rear end
of battery) using 13-mm open-end wrench. See
(a) Open right front door and unsnap clip to release
tension on engine access panel. Remove the
lower right acess panel from engine
(c) Disconnect connector P42 from cable to
compartment using flat-tip screwdriver to
forward end terminals of the batteries.
loosen five slotted captive screws. See figure
2-37.
(d) Disconnect the negative cable from the heater
plate at rear end of batteries, using 13-mm
open-end wrench. Pull negative cable forward
(b) Remove the two bottom screws from the panel
for later working room clearance.
by removing the nylon retainers from rear of the
panel.
(11) Removal of Clips. Remove clips as follows
(c) Place retainers in a plastic hug and mark "Front
(a) Open left front door. Using a 10-mm open-end
right engine panel screw retainers. " Tie bag and
wrench, remove two bolts securing clip to
stow in SUSV toolbox.
driver's seat support (see figure 2-39).
(d) Reinstall access panel with two bottom screws.
(b) Remove two bolts securing clip to driver's
Do not tighten lower two screws.
backrest support.
(8) Removal of Heater Access Cover and Brace-
(c) Remove the clips and reinstall the four lo-mm
Remove cover and brace as follows:
bolts loosely in supports to be used later.
(d) Place the two clips in a plastic bag and mark,
(a) Using a 10-mm open-end wrench. remove six
"Clips to driver's seat and backrest supports.
bolts securing beater access cover and brace
Reinstall with 10-mm open-end wrench." Tie
located just forwward of the engine access panel
bag and stow in Susv toolbox.
(see figure 2-37). Reinstall bolts loosely.
(12) Removal of Upper Engine
Access Cover.
(b) Place cover and brace in a plastic bag and
Remove cover as follows:
mark "Heater access cover and brace for small
opening at bottom right front of engine cover.
(a) Cover extends half length of front ear.
Use 10-mm open-end wrench to install." Tie
bag and stow in SUSV toolbox.
(b) Unlatch fasteners at locations over its length.
Stow cover in rear car until needed.
(c)
Change 2
2-52
Previous Page
