ARMY TM 5-6675-308-12
MARINE CORPS TM 08837A-12/1A
(g) Route the branch of the W7 cable with the red
(k) Replace the commander's seat; latch in place.
band (wire marked positive) to the center of the
(l)
Attach connector W7P1, on free end of cable
battery compartment and connect to the positive
post of the forward battery. Install the hardware
W7, to power supply connector 3J4. The power
so the W7 cable battery connection can be re-
supply is on the curb side of the PADS primary
moved without removing the existing battery
pallet as installed (see figure 2-35).
connection. Tighten the hardware using the
(m) Connect cable W6 (item 6, figure 1-5) from bat-
9/16-inch wrench.
tery box to power supply connector 3J2 (see fig-
ure 2-35).
(h) Install grommets, previously installed on cable
branches, in both 1-inch holes (See figure 2-33).
(8) Install the control and display unit (CDU) as
follows:
(i) Replace the interconnect cable between the posi-
(a) Unsnap CDU from its bracket on top of PADS
tive post of the rear battery and the negative post
primary pallet (item 2, figure 1-4). Route CDU
of the front battery. Tighten the hardware using
and cable assembly W1 as shown in figure 2-35.
the 9/16-inch wrench.
(b) Secure CDU to CDU bracket on the mounting
(j) Replace the vehicle ground cable and tighten the
frame using the two clamping catches (see
hardware using the 9/16-inch wrench.
2-48
Previous Page
