TM 5-6675-250-10
2-9. PREPARATION FOR MOVEMENT
MOVEMENT TO A NEW LOCATION
a.
Verify that the MODE SELECT switch (1) is
in the PWR OFF position (2).
When placing cables in ECU cover, care must
be taken to avoid cable contact with the
plunger of the pressure release valve. Dis-
turbing the plunger voids the water-tight
characteristics of the case.
b.
Disconnect interconnect cable (1) from the
ECU (2) and GRU (3).
Install protective cap (6) on GRU and pro-
c.
tective cap (7) on ECU.
d.
Disconnect DC power cable (4) from power
receptacle (5) and install protective cap (8)
or input power connector.
The interconnect and power cables are
e.
stored in the cover of the electronic con-
trol unit case; cables used in conjunction
with the AC-DC converter are stored in the
transport case storage compartment.
2-58
Previous Page
