TM 32-5865-010-24&P
GENERAL SUPPORT MAINTENANCE INSTRUCTIONS
Section I.
GENERAL
Scope.
This chapter contains general support maintenance instructions on
the DF control-indicator. Maintenance instructions consist of
testing, troubleshooting? disassembly, assembly and repair procedures,
and are limited in scope to those procedures authorized in the
maintenance allocation chart in appendix B. General support
maintenance personnel, using tools and test equipment listed in
section II, troubleshoot the unit in accordance with procedures
detailed in section IV. The unit is then tested in accordance with
performance.test procedures in section V, to verify that the fault has
been successfully found and repaired.
Section II.
TOOLS AND TEST EQUIPMENT
Standard Tools and Test Equipment.
A list of tools and test equipment required to support the DF
control-indicator at the general support level of maintenance. The
table consists of an item number column, a nomenclature column, and an
NSN or FSCM number column.
Special Test Equipment.
The OQ-337/ALQ-151 Test Set Group is required for the testing of
the DF control-indicator at the general support level. No special
tools are required.
Tools and Test Equipment for General Support Maintenance
NSN or FSCM number
Nomenclature
Item no.
6625-01-068-1667
Maintenance Kit MK-1961/G
1
2
Tool Kit TK-105/G
3
Tool Kit TK-100/G
4
Riveter Kit HP-200
5