TM 11-5826-225-35
(11) Check that shaft of tuning capacitor
subassembly fis into hub of tuning
c a p a c i t o r drive feaar (65). Then
(1) Position subassembly (fig. 3-1) on re-
t i g h t e n two setscrews 68, lock).
ceiver chassis.
Final adjustment of the tuning ca-
(2) Replace one screw and lockwasher (C,
pacitor subassembly is performed in
3-2, lock). Do not tighten screws fully
until switch shaft (m below) has been
e. Replacement of Bfo Subassembly.
replaced.
(1) Position subassembly (fig. 3-2) on
l. Repalcement o f Push-Pull RF Amplifier
receiver chassis.
Subassembly.
( 2 ) Replace five screws (J).
(1) Position subassembly (fig. 3-1) on re-
f. Replacement of Audio Frequency Ampli-
ceiver chassis.
fier Subassembly.
(1) Position subassembly (fig 3-2) on
receiver chassis.
3-2). Do not tighten screws fully until
(2) Replace five screws (H, lock).
switch shaft (m below) has been re-
placed.
g. Replacement of IF Amplifier Subassem-
placement of Swircth Shaft.
bly.
(1) Position subassembly (fig. 3-1) on re-
ceiver chassis.
(2) Replace seven screws (G, lock).
h. Replacement of Local Oscillator Assembly
(1) Position subassembly (fig. 3-1) on re-
ceiver chassis.
(2) Replace one screw and lockwasher (E,
lick). Do not tighten screws fully un-
(2)
til switch shaft (m below) has been re-
placed.
i. Replacement of Mixer Subassembly.
(1)
(2)
(1)
3-10
Previous Page
