TM11-5826-225-35
(4) Remove two screw's (N, fig. 31) on
top of receiver chassis.
(13)
(5) Remove two screws on bottom of re-
ceiver chassis which are directly op-
posite from two screw in (4) above.
(14)
(6) Slide gear train subassembly toward
rear of receiver until subassembly is
free.
Disassembly of Gear Train Subassembly
n.
(15)
Note. Some of the items of the gear train subassem-
bly are removed or loosened when the subassembly is
(16)
removed from the receiver chassis (m above). These
items are two setscrews (119), two setscrews (68), two
screws (101), two Iockwashers (100), and cover (102).
Removal or loosening of these items are not repeated
(17)
in the disassembly procedures below.
(1) Remove two screws ( 116) anti two
(18)
lockwashers ( 115) from front gear
plate ( 103).
(2) Remove screw ( 104) and lockwasher
(19)
( 1 0 5 ) at upper right corner of front
gear plate.
(20)
(3) R e m o v e s c r e w (111), lockwasher
(112), flat washer (113), and dowel
(21)
(114) at lower right corner of front
gear plate.
(22)
( 1 ) Remove screw (122) and lockwasher
(123) at upper left corner of front
(23)
gear plate.
lockwasher
( 5 ) Remove screw
(124).
(21)
(l25), flat washer (126), and dowel
(127) at lower left corner of front
(25)
gear plate.
( 6 ) Remove two screws (120) and two
(26)
lockwashers (121) that secure side
plate (72) to front gear plate.
(7) Remove screw (38) anti lockwasher
(37). Spacer (81) will be free.
(27)
( 8 ) Loosen two setscrews (97) on collar
(98).
( 9 ) Remove extension spring (117)
(28)
(10) Loosen two setscrews (119) on switch
s h a f t coupler (118), and remove
switch shaft coupler.
(29)
(11) Pull off front gear plate (103) and
attached parts.
(30)
(12) Remove three screws (109), three
3-3
Previous Page
