TM 5-6675-312-14
CHAPTER 3
OPERATOR MAINTENANCE INSTRUCTIONS
Section I. LUBRICATION INSTRUCTIONS
(There are no operator lubrication requirements.)
Section II. TROUBLESHOOTING PROCEDURES
(There are no operator troubleshooting procedures.)
Section III. MAINTENANCE PROCEDURES
3-1. GENERAL Operator maintenance is limited to installing the battery box assembly, handlamp, plug-in lamp,
autocollimation eyepiece, circular compass assembly, telescope level, and tribrach assembly, and servicing the tripod.
3-2. INSTALLATION
a. Battery Box Assembly. To install the battery box assembly on the tripod refer to figure 3-1.
b. Headlamp. To install the headlamp refer to figure 3-2.
c. Plug-in Lamp. To install the plug-in lamp refer to figure 3-3.
d. Autocollimation Eyepiece. To install the autocollimation eyepiece refer to figure 3-4.
e. Circular Compass Assembly. To install the circular compass assembly refer to figure 3-5.
f. Telescope Level. To install the telescope level refer to figure 3-6.
g. Tribrach Assembly. To install the tribrach assembly on the theodolite refer to figure 3-7.
3-1
Previous Page
