ARMY TM 5-6675-308-34
MARINE CORPS TM 08837A-34/2
Table 4-6.2. Solid State Memory Loading- Continued
Malfunction
Test procedure
Normal indication
indication/corrective action
I/O discrete circuit card assembly A9
Control no. 2 circuit card assembly A4
Control no. 1 circuit card assembly A3
16-bit data circuit card assembly A2
NOTE
TTY prints out:
Memory clear routing will begin automat-
MEMORY TEST FAIL
ically. When completed, TTY will print
Replace cards in sequence given:
out LOAD NEXT TAPE SECTION
Memory unit Al
16-bit data circuit card assembly A2
Control no. 2 circuit card assembly A4
Control no. 3 circuit card assembly A5
Control no. 1 circuit card assembly A3
lj. Press EXECUTE switch-
EXECUTE switch-indicator goes off
EXECUTE switch-indicator remains
indicator to off to halt computer
on:
Same card replacement as step 1i
2. SOLID STATE PROGRAM
LOAD
2a. Press MEMORY LOAD switch-
Tape stops before end of tape. Replace
MEMORY LOAD switch-indicator
indicator to on to load program
lights. Tape reader reads tape and stops
tape or rerun clear memory routine
after first reel has been read
and attempt to load again
NOTE
NOTE
Press MEMORY LOAD switch-
Ignore PARITY ERROR switch-
indicator off and back on if a stop
indicator light unless tape stops.
code is reached prior to taped data
being read.
2b. PressMEMORYLOAD switch MEMORY LOAD switch-indicator goes
indicator to off
off
2c. Press REVERSE switch- REVERSE switch-indicator lights. Tape
inicator to on
rewinds and stops at beginning of reel
2d. Press REVERSE switch- REVERSE switch-indicator goes off
indicator to off
NOTE
Tape will stop near the beginning of
the reel. Repeat steps 2c and 2d until
tape stops at end of readable leader.
2e. Set tape reader SPOOLING
switch to DISABLE
2f. Remove part 1 and load part 2
(of 3) of PADS solid state pro-
gram 868182-X on tape reader
2g. Set tape reader SPOOLING
switch to ENABLE
2h. Press MEMORY LOAD switch- MEMORY LOAD switch-indicator
indicator to on
lights. Tape reader reads tape and stops
at end of reel
4-54.12
Change 6