ARMY TM 5-6675-308-12
MARINE CORPS TM 08837A-12/1A
Legend for Figure 1-7- Continued
Description
Index no.
omenclature
Quick-release pin
To secure CDU mounting bracket to mount tube in SUSV.
25.
To attach quick-release pinto CDU mounting bracket in SUSV.
26.
Chain
27.
To secure cable W101 in SUSV.
Cable clamp
Plumb bob assembly
28.
Used to hang plumb bob to establish position reference point in
SUSV.
Installed under SUSV as stiffener base for SUSV body.
29.
Floor support plate
Installed on floor support plate in SUSV to mount PADS
30.
Frame assembly
components.
31.
Left bracket
Used to secure PADS primary pallet to left side of frame assembly.
Right bracket
Used to secure PADS primary pallet to right side of frame assembly.
32.
Power cable for installation of PADS on SUSV.
33.
Cable assembly W100
For component interconnection on frame assembly in SUSV.
34.
Cable assembly W101
For interconnection of PADS installation components on SUSV.
35.
Cable assembly W102
Power cable connector
To connect PADS installation to SUSV power through adapter.
36.
To adapt power cable connector to SUSV auxiliary starting
37.
Connector adapter
connector.
Power cable from back-up power source to PADS.
38.
Cable assembly W6
For interconnection of PADS batteries.
39.
Cable assembly W11
40.
Used for SUSV operation.
Shock mount
41.
Used with adapter frame, index no. 7.
Modified subfloor
plate
Used with modified subfloor plate when installed in utility truck.
42.
Subfloor mounting
bracket
l/4-inch diameter by 5/8-inch long bolt (four each), and flat washer
Hardware
Not shown
(four each) to secure subfloor plate to subfloor mounting bracket.
3/8-inch diameter by l-inch long bolt, flat washer, lockwasher, and
nut to secure cable clamp to utility truck.
Grommet (four each) for cable assembly W7 access holes in utility
truck, CUCV and HMMWV.
5/8-inch diameter by 1.38-inch long bolt (four each) and flat washer
(four each) to secure mounting base and spacers into CUCV cargo
bed.
l/2-inch diameter nut (two each) and lockwasher (two each) used
with J-bolts and anti-rotation washers to secure mounting base
into CUCV cargo bed.
1-17
Change 3
Previous Page
