TM 5-6675307-14
Figure 5-5. Compass holder (pivot ) assembly, removal
Figure 5-4. Plate level, removal and installation.
and installation.
b. Inspection.
c. Inspection.
(1) Inspect vial for cracks, scratches, etching
(1) Inspect pivot for distortion and condition
and defective bubble.
of tip.
(2) Check metal portion for cracks and
(2) Check condition of threads.
distortion.
d. Replacement. If any damage is noted, replace
(3) Replace level if any damage exists.
holder assembly.
c. Installation. Install plate level in reverse order
e. Installation. Install holder assembly in reverse
of removal.
order of removal.
5-15. Compass Holder (Pivot) Assembly, Removal
and Installation
a. General. The compass holder (pivot) assembly
serves as the pivot for the compass needle. The pivot
has a very precisely machined point and must be
handled with care. Be sure that no dirt or moisture
enters the compass during replacement. Spare holders
are contained in the tool and accessory case.
b. Removal. Refer to figure 5-5 and remove
holder assembly.
5-6