TM 5-6675-307-14
CHAPTER 4
ORGANIZATIONAL MAINTENANCE INSTRUCTIONS
SECTION I. SERVICE UPON RECEIPT OF MATERIAL
4-1.
Inspecting and Servicing the Equipment
4-2.
Setting Up the Equipment
Inspecting and servicing of the theodolite and its
Instructions for preparing the theodolite
and
its
accessories is covered in paragraph 2-1.
accessories are given in paragraph 2-2.
SECTION II. MOVEMENT TO A NEW WORKSITE
4-3.
Movement to a New Worksite
4-4.
Setting Up After Movement
Refer to paragraph 2-4 for instructions on preparing the
Refer to paragraph 2-5 for instructions on setting up the
theodolite for movement to a new worksite.
theodolite after movement to a new worksite.
SECTION III. REPAIR PARTS, SPECIAL TOOLS, AND EQUIPMENT
4-5.
Tools and Equipment
References and illustrations indicating the use of these
tools are listed in table 4-1. References and illustrations
Tools, equipment, and repair parts issued with or
indicating the use of these tools are listed in the table.
authorized for the theodolite are listed in the basic issue
The five-digit number preceding the stock number or
items list and items troop installed or authorized list,
manufacturer's part number is the Federal Supply Code
Appendix C.
for the manufacturer of tool(s). No special equipment is
4-6.
Special Tools
required by organizational maintenance personnel for
performing maintenance on the theodolite.
he special tools required to perform organizational
maintenance on the theodolite are listed in table 4-1.
Table 4-1. Special Tools
Figure
Item
NSN or Part No.
Reference
Use
Pin, adjusting: 0.040 in
(33363) * A52130
2-7
Adjust theodolite adjusting screws.
Pin, adjusting: 0.050 in
(33363) * S7865-4
2-7
Adjust theodolite adjusting screws.
Pin, adjusting: 0.0
(33363) * S7865-3
2-7
Adjust theodolite adjusting screws.
Wrench, tangent screw
(33363) * A 51966
2-7
Tighten tangent screw housing.
*Federal Supply Code for the manufacturer.
4-7.
Maintenance Repair Parts
307-24P, covering organizational maintenance for this
equipment.
Repair parts and equipment are listed and illustrated in
the repair parts and special tools list, TM 5-6675-
4-1
Previous Page
